10 ENGLISH BOOKS RELATING TO «TURN THE SCREW»
Discover the use of
turn the screw in the following bibliographical selection. Books relating to
turn the screw and brief extracts from same to provide context of its use in English literature.
1
Remarks on "
The Reports Relative to Smith's Patent
Screw ...
A very different reason, however, may. be given to account for the want of power
in the engines to turn the screw at the said “requisite” velocity, viz. the immense
resistance produced by the friction or adhesion of the water against the thread of
...
2
THE MAGAZINE OF SCIENCE AND SCHOOL OF ARTS
Set the tool to cut a line of the requisite depth, and turn the screw at the end of G,
(slide rest) till the transverse slider has passed over one inch, this of course will
out a circle 2 inches in diameter, turn the screw at the end of the eccentric chuck ...
3
SIP Scooter Catalogue ENGLISH
Turn the screw in until the idling mix reaches the highest rpm's, then turn back a
quarter turn. Lastly, adjust the idle mix through the idle adjustment screw. That's it
! The air adjustment screw. The air adjustment screw regulates the amount of air,
...
4
Automobile Carburetor Manual:
Next, turn the idle-adjusting screw out until the engine starts to miss, and then
turn the screw in until the engine runs evenly. Speed the engine up for a few
seconds by opening the throttle valve so as to clear the manifold, and then
recheck the ...
5
Gunsmithing - Pistols and Revolvers
Press the lock nut against the shaft and turn the screw just Slide the blade
assembly into the housing. enough to get the nut started on the threads. Hold the
adjustment lock nut in place while you turn the adjustment screw. The ramp
guides the ...
6
Writing and Designing Manuals, Third Edition
Now turn the screw clock wise until it begins to move the throllte tever: then
conlinue lurning 2 full turne. 3. Initial High Speed end Idte Mixture Settmg: Turn
both the high and idle mixture screws clockwise (Fig. 26I until they are lightly
sealed ...
Ryn Etter, Patricia A. Robinson, 2000
7
The Magazine of Science, and Schools of Art
Set the tool to cut a line of the requisite depth, and turn the screw at the end of C,
(slide rest) till the transverse slider has passed over one inch, this of course will
eat a circle 2 inches in diameter, turn the screw at the end of the eccentric chuck ...
8
Henry James and
the Ghostly
In The American, Valentin observes that his family 'must have had to turn the
screw pretty tight' in order to accept Newman as Claire's suitor {Novels 187 1-
1880, p. 674). These instances of the turning screw describe resolutions, acts of
will ...
9
Donny_s Unauthorized Technical Guide to Harley-Davidson, ...
On 1976 to early-1978 Kehein carburetors, there is an adjustable idle (low speed
) screw (27315-76) and tensioner spring (27319-76) on the top-rear ofthe
carburetor body. The settings are: Turn the screw clockwise in until it lightly
bottoms on ...
10
Instant-Answer Guide to Business Writing: An A-Z Source for ...
The automatic screwdriver, like a conventional screwdriver, contains a solid
metal rod with a bit on the end. But it differs because the solid rod rotates inside a
metal tube that is attached to the handle you twist to turn the screw. You can
connect ...
Deborah Dumaine, Elisabeth C. Healey, 2003