«FEEDPIPE»に関連する英語の本
以下の図書目録から
feedpipeの使いかたを見つけましょう。
feedpipeに関する本と英語文献で使われた文脈を提供するための簡単な抜粋文。
1
Chemical Process Equipment: Selection and Design
4. Ratio of initial batch volume to semi-batch feed volume = 80. 5. Feed time of
semi-batch feed = 15 minutes = 900 sec. 6. The feedpipe discharges vertically
downward very near the impeller shaft. 7. G = 0:0173G/D = 0:0173/0:0365 = 0:47
8.
2
When Voices Clash: A Study in Literary Pragmatics
Technically speaking, the 'reference' (for this, see the next chapter) of 'it' could
just as well be 'the feedpipe' as 'the chain'. However, a 'competent' reader (cf.
chapter 9.1) will be expected to automatically assign the reference to the former ...
3
Focus and Coherence in Discourse Processing
For instance, it is possible to produce examples where reference resolution
necessarily has to precede inference: (5) The feedpipe lubricates the chain, and
it should be adjusted to leave a gap half an inch between itself and the sprocket.
Gert Rickheit, Christopher Habel, 1995
4
The Steam Engine Explained and Illustrated: With an Account ...
The column of water sustained in the feedpipe {figs. 71, 72.) represents by its
weight the difference between the pressure of steam within the boiler and that of
the atmosphere. If the engine consumes steam faster than the boiler produces it,
the ...
Tests were conducted with water flowing through a 0.95 cm feedpipe into a NaCI
solution in a 11.2 liter vessel. The minimum feedpipe flowrates to eliminate
backmixing were determined for a test program using six bladed disk and HE-3 ...
American Institute of Chemical Engineers, Gary B. Tatterson, Richard Calabrese, 1994
6
Process mixing: chemical and biochemical applications
However, the quantitative effect of the feedpipe backmixing on their data cannot
be determined. The effect of feedpipe backmixing on Paul 1 s data could have
been less than the effect on Bourne's data because Paul 1 s feedpipe was ...
Gary B. Tatterson, Richard Calabrese, W. Roy Penney, 1993
7
Industrial mixing technology: chemical and biological ...
Tests were conducted with water flowing through a 0.95 cm feedpipe into a NaCI
solution in a 11.2 liter vessel. The minimum feedpipe flowrates to eliminate
backmixing were determined for a test program using six bladed disk and HE-3 ...
Gary B. Tatterson, Richard Calabrese, W. Roy Penney, 1994
The high flow velocity in the radial-axial plai at the feedpipe locations apparently
results in flow separation at the nozzle tip wall, which causes the large total-
pressure losses observed. Nozzle mean and hub section total-pressure losses at
the ...
The high flow velocity in the radial-axial plane at the feedpipe locations
apparently results in flow separation at the nozzle tip wall, which causes the large
total-pressure losses observed. Nozzle mean and hub section total-pressure
losses at ...
Roy G. Stabe, David G. Evans, Richard J. Roelke, 1966
10
Cold-air performance evaluation of scale model oxidizer ...
The variation in feedpipe static- to total- pressure ratio with turbine- inlet total- to
turbine- exit static- pressure ratio at equivalent design speed is shown in figure
15(a). The static pressure p^ is the average of the four wall taps in each feedpipe,
...
Richard J. Roelke, Roy G. Stabe, David G. Evans, 1966
用語«FEEDPIPE»を含むニュース項目
国内外の報道機関が語った内容や、次のニュース項目の文脈から
feedpipeという用語がどのように使われているかを調べてみましょう。
Pronomar Tackles Lime Scale Issue on VOS Sweet
Pronomar then installed the following MERUS rings on the VOS Sweet: 2 1/2” IND BIO ring for the hydrophore, 2” IND ring on the feedpipe of ... «MarineLink, 5月 15»
Science chief warns on acid oceans
It grips the water feedpipe with a vicious-looking claw. “We think crabs should fare better with low pH than urchins do,” she tells me. “We don't ... «BBC News, 10月 14»
Maximise your recoveries in a flash
These include poor solids suspension and sanding and inadequate mixing of water and solids in the feedpipe. Additionally, the froth booster ... «The Australian Journal of Mining, 6月 11»
Versatile Suzuki Grand Vitara Diesel Arrives in NZ
Fuel is precisely bled off from a highly pressurised reservoir commonly shared by every injector along the feedpipe or "rail". Exactly the correct ... «Scoop.co.nz, 3月 06»
