MIT «POST-CYCLIC» VERWANDTE WÖRTER IM WÖRTERBUCH ENGLISCH
post-cyclic
post
cyclic
define
transformational
grammar
compare
last
denoting
rules
that
apply
only
after
transformations
whole
cycle
reverso
meaning
also
postvocalic
behaviour
clayey
soil
springer
subjecting
loading
presented
this
paper
tests
were
carried
samples
want
thank
shear
strength
fine
grained
soils
determine
static
clays
undisturbed
softening
monotonic
collins
always
adjective
sense
effect
primary
objective
systematically
undrained
strengths
plastic
silty
silts
results
with
behavior
crushed
conglomerate
study
sign
material
degradation
stress
strain
curves
compared
under
saturated
mixed
researchgate
main
focus
singapore
marine
clay
cfms
abstract
remoulded
herein
reveal
effective
paths
10 BÜCHER, DIE MIT «POST-CYCLIC» IM ZUSAMMENHANG STEHEN
Entdecke den Gebrauch von
post-cyclic in der folgenden bibliographischen Auswahl. Bücher, die mit
post-cyclic im Zusammenhang stehen und kurze Auszüge derselben, um seinen Gebrauch in der Literatur kontextbezogen darzustellen.
1
Cyclic Behaviour of Soils and Liquefaction Phenomena: ...
1.5 = 0.225A (lib) As was mentioned above, post-cyclic characteristics with and
without post-cyclic drainage are related to the normalized pore water pressure
generated during undrained cyclic loading. Therefore, it is necessary for the ...
Th. Triantafyllidis, 2004
2
Earthquake Hazards and Mitigation
Post cyclic test results show dilative behavior which confirms the apparent over
consolidation due to cyclic loading. Stress paths of monotonic loading of samples
without prior cyclic loading is similar to general normally consolidated clay ...
3
Hospitality and Tourism: Synergizing Creativity and ...
A typical cyclic loading test, followed by the corresponding post-cyclic test and
the monotonic reference test, is plotted in Figure 5. For clarity, only the first and
the last cycles are shown. It is possible to note that a small loss of applied
moment is ...
Norzuwana Sumarjan, Zahari Mohd Salehuddin Mohd, Radzi Salleh Mohd, 2013
4
Ecology of the Acanthocephala
2.6 POST-CYCLIC TRANSMISSION Post-cyclic transmission is yet another
means by which the Acanthocephala can escape from the rigidity of the single
intermediate host life cycle. For a long time it had been difficult to understand how
...
5
Soft Soil Engineering: Proceedings of the Fourth ...
Post-cyclic pullout load-displacement curves for anchors subjected to pre-cycling
load ratio level of 0.45. level increases, whereas, the relative cyclic stiffness
increases. The relative postcyclic stiffness is found to vary between 1 . 1 69 to 1 .
282 ...
Dave H. Chan, K. Tim Law, 2006
6
Geo-Frontiers 2011: Advances in Geotechnical Engineering
Figure 7 presents ) – 7 curves for the post-cyclic static shear tests conducted for .
n,s = 692 kPa. After cyclic loading, each specimen was permitted to rest for a
minimum of 24 hr. at the same normal stress to allow for dissipation of any excess
...
Jie Han, Daniel E. Alzamora, 2011
7
Linguistic Representation: Structural Analogy and Stratification
Say too that in English subjectforrnation can then apply both cyclically and post-
cyclically: the cyclic application is not structure-changing, and so access to CRs
remains available to cyclic rules and post-cyclic rules (including, as we shall see,
...
8
Pre-failure Deformation Behaviour of Geomaterials
summation of the cyclic-induced residual axial strains and the post-cyclic axial
strains. As in Fig. 6 for no cyclic loading, post-cyclic axial strain against effective
stress ratio relations are plotted in Fig. 14. In this case the degree of convergence
is ...
9
The Geotechnics of Hard Soils - Soft Rocks -
This incident will have affected the subsequent cyclic behaviour, and possibly
have contributed to the higher post-cyclic strength, however, it is not believed to
have significantly affected the results. The reason for the increase in post-cyclic ...
Aldo Evangelista, Luciano Picarelli, 1998
10
Tclee 2009: Lifeline Earthquake Engineering in a Multihazard ...
After completion of the cyclic loading, some samples were tested to determine the
post-cyclic volumetric strain of the material, and some samples were tested to
determine the post-cyclic undrained shear strength of the material. The results of
...
Alex Tang, Stuart D. Werner, 2009