«RAINTIGHT»に関連する英語の本
以下の図書目録から
raintightの使いかたを見つけましょう。
raintightに関する本と英語文献で使われた文脈を提供するための簡単な抜粋文。
1
Electrical Wiring Residential
Raintight and Draining Outdoor locations are generally wet locations. However,
under an overhang may be considered a damp rather than a wet location. If you
are using EMT outdoors in a wet location, the fittings (couplings and connectors)
...
Ray Mullin, Phil Simmons,
2011
2
NEC Q and A: Questions and Answers on the National ...
Question. 2.9. Are. goosenecks. permitted. to. be. located. below. service. drop.
conductors? Keywords. Gooseneck Service head Weatherhead Service drop
Raintight Point of attachment ...
Noel Williams, Jeffrey S. Sargent,
2007
3
Audel Guide to the 2011 National Electrical Code: All New ...
230.53: Raceways to Drain Serviceentrance raceways, when exposed to weather
, shall be raintight and arranged todrain. Ifembedded in concrete theyshallalso be
arranged to drain. A particular incident is worth mentioning here: A large ...
4
Interpreting the National Electrical Code
The previous edition of the Code required raceway to be raintight in wet locations
. Most fittings suitable for use in wet locations are not listed as raintight. 225.27:
Raceways entering a building or structure from an underground distribution ...
Truman Surbrook, Jonathan Althouse,
2011
5
NFPA's Pocket Electrical References
... prolonged submersion at a timited depth: and that will be undamaged by the
external formation of ice on the enclosure Raintight; watertight Raintight;
watertight; corrosion resistant Dri plight; dusttight Raintight; watertight Raintight:
watertight; ...
6
One and Two Family Dwellings 2008: Based on the NEC and ...
RAINTIGHT. SERVICE. HEAD. OR. GOOSENECK. 230.54(B). Service-entrance
cable shall be installed in the form of a gooseneck and then taped and painted or
plastic coated for protection from the weather. The entrance of rain through a ...
James G. Stallcup, James W. Stallcup,
2009
7
Taunton's Wiring Complete: Expert Advice from Start to Finish
Aboveground, electrical cable must be housed in conduit with raintight fittings (
see bottom photo at right). You can use polyvinyl chloride (PVC), thin-walled
electrical metallic tubing (EMT) conduit, threaded intermediate metal conduit (
IMC) or ...
Michael W. Litchfield, Michael McAlister,
2008
8
Unit, Direct Support, and General Support Maintenance ...
6. Remove nut (9) and remove raintight connect (10). NOTE Before installing the
replacement high-limit control (4), coat threads with thread sealer compound (
Item 5,AppC). 7. Install raintight connector (10) and nut (9) in high-limit control (4).
9
Shale Shakers and Drilling Fluid Systems: Techniques and ...
1 General Purpose — Indoor 2 Driproof — Indoor 3 Dusttight, Raintight, Sleettight
— Outdoor 3R Raintight, Sleet Resistant — Outdoor 3S Dusttight, Raintight,
Sleettight— Outdoor 4 Watertight, Dusttight, Sleet Resistant — Indoor & Outdoor
4X ...
American Association of Drilling Engineers,
1999
10
Electrical Inspection Manual, 2014 Edition
Raintight Constructed or protected so that exposure to a beating rain will not
result in the entrance of water under specied test conditions. [e term raintight is
typically used in conjunction with enclosure Types 3, 3S, 3SX, 3X, 4, 4X, 6, and
6P.] ...
Noel Williams, Jeffrey S. Sargent,
2014
用語«RAINTIGHT»を含むニュース項目
国内外の報道機関が語った内容や、次のニュース項目の文脈から
raintightという用語がどのように使われているかを調べてみましょう。
Building permits: Jan. 29 to Feb. 4
... 803 Crepe Myrtle Lane, install electric at new dwelling
Kenny Sims Electric, 14 Spring Valley Circle, replace bad raintight breaker box and breaker at ... «Longview News-Journal, 2月 15»
Center to reopen Tuesday after water damage
Since it was indoors, there is no code requirement for watertight fittings on conduit systems, and the use of NEMA 3R (Raintight) equipment is not required either. «Tbo.com, 6月 14»
Emergency Lighting System suits hazardous locations.
The CID2 is rated NEMA 3R (raintight), and is ruggedly built from compression molded, fiberglass reinforced polyester, formed with a continuous silicone gasket ... «ThomasNet News, 5月 14»
Raintight EMT Fittings require no disassembly. .
ROSEMONT, IL – Raintight fittings are required by code to safely ground and attach EMT raceways to electrical junction boxes or enclosures in outdoor, damp ... «ThomasNet News, 3月 14»
Raintight Reducing Sealing Washers eliminate need for caulking.
STRATFORD, Conn., - To help make a contractor's job easier and quicker, Bridgeport Fittings has introduced Mighty-Seal(TM) Raintight Reducing Sealing ... «ThomasNet Industrial News Room, 6月 12»
Crane & Boom Obstruction Lights - Solar LED
The Model SLX-15 is raintight and offers two mounting options namely, permanent mounting with its (3) threaded studs on 1-¾" radius center, 120 degrees apart ... «ThomasNet Industrial News Room, 4月 12»
Conduit Couplings feature watertight seal.
December 16, 2010 - Available in sizes from ½-4 in., 3-piece Mighty-Align(TM) Raintight Couplings have self-aligning design that ensures 360° watertight seal ... «ThomasNet Industrial News Room, 12月 10»
Raintight Fittings are available in steel and zinc.
July 17, 2007 - UL-Listed EMT concrete-tight, raintight connectors feature split-type gland ring that prevents conduit from turning when tightening hex nut. Fittings ... «ThomasNet Industrial News Room, 7月 07»