«SINGLE-CUT FILE» 관련 영어 책
다음 도서 목록 항목에서
single-cut file 의 용법을 확인하세요.
single-cut file 에 관련된 책과 해당 책의 짧은 발췌문을 통해 영어 서적에서 단어가 사용되는 맥락을 제공합니다.
The single-cut file has single rows of teeth cut parallel across its faces at an angle
of from 65 to 85°, depending on the form of the tool and the work for which it is
intended. The double-cut file has two rows of teeth cut on each face crossing ...
... varying in size and shape and in the qualities of coarseness, These
photomicrographs show the patterns of a regular single-cut file (below), a double-
cut file (lower right), and a wood rasp (at right) Essential differences between a
single-cut ...
Single cut file 2. Double cut file 3. Rough cut file These are shown in Fig. 9.30.
Single cut file Double cut file Rough cut file Fig. 9.30 Files with different cuts.
Table 9.1 Classification of files based on grades of teeth Types of cut No. of teeth/
cm ...
4
Precision Machining Technology
When you use a single-cut file, the file will cut in only one direction. With the file
handle in the right hand, a single cut file will cut on the forward stroke. With the
file handle in the left hand, a single cut file will cut on the back stroke. When you ...
Peter Hoffman, Eric Hopewell, Brian Janes, 2014
5
Aviation Maintenance Technician's Handbook
The single cut file has a single row of teeth extending across the face at an angle
of 65° to 85° with the length of the file. The size of the cuts depends on the
coarseness of the file. The double cut file has two rows of teeth that cross each
other.
A single-cut file has its cutting grooves lined up diagonally across the face of the
file. The cutting grooves of a double-cut file run diagonally in both directions
across the face. Double-cut files are considered first cut or roughening files
because ...
The relative coarseness of the teeth from extreme coarse to very fine is
designated by the terms rough, coarse, bastard, second cut, smooth and dead
smooth. In general, the single-cut file is used most commonly under relatively
light pressure ...
8
MECHANICAL WORKSHOP PRACTICE
Edge\. N. l/ Lenglh 2 Cut and spacing of teeth on file The teeth on a file may be of
single cut or double cut. A single cut file will be having parallel teeth at 60°
inclination to the centre line and is also known as flat files. Double cut files have
two ...
9
Agricultural Mechanics: Fundamentals & Applications
If a file has straight teeth going in one direction, it is said to be a single-cut file. If a
file has teeth going in two directions, it is a double-cut file. A double-cut file cuts
faster than a single-cut file. Single-cut and doublecut files can be purchased in ...
Classification Based on Cut Files are also classified according to the type of cut
as (a) single cut file, (b) double cut file, (c) rasp file, and curved tooth file as
shown in Fig. 4.7. A single cut file has teeth in a single row over its body as
shown in ...
