«TAIL GATE» 관련 영어 책
다음 도서 목록 항목에서
tail gate 의 용법을 확인하세요.
tail gate 에 관련된 책과 해당 책의 짧은 발췌문을 통해 영어 서적에서 단어가 사용되는 맥락을 제공합니다.
The power unit is placed on the ground beside the tail gate of the wagon and
power is transmitted to the cable take-up shaft by a telescoping drive shaft. Two
cables pull a false tail gate to the rear of the wagon, spilling the load. A third
cable ...
2
Operator, Organizational, DS, and GS Maintenance Manual: ...
FOR TRUCK, OPEN TAIL GATE. STEP 2 REMOVE CANVAS COVER AND
BOWS FROM TRUCK OR SIDE RACKS FROM SEMITRAILER. STEP3 ATTACH
HANDLINGSLING TOIIFTPOINTSON PROGRAMMER-TEST STATION AND/OR ...
3
Transitional Flow Between Orifice and Non-orifice Regimes at ...
The incremental changes in tail gate setting were small enough to provide
different submergence values (hd/hu). Special attention was given near the
transition from non-orifice to orifice; thus, smaller increments in the tail gate were
made ...
Omar Alminagorta Cabezas, 2008
4
Advances in Affective and Pleasurable Design
3 DEVELOPMENT OF SATISFACTION AND EFFORT MODEL OF SUV TAIL
GATE 3.1 Effect of customer variables on satisfaction and effort of closing/
opening tail gate Analyzing the effect of each customer variable such as age,
height, driving ...
5
Proceedings Geomechanics and Ground Control
However, when the face was at about 1 00 m in the main gate and at about 90 m
in the tail gate, the convergence points close to the face recorded an increase of
10 mm/day in the main gate, and 7 mm/day in the tail gate prior to the main fall in
...
6
Pay and Productivity Bargaining: A Study of the Effect of ...
On the other hand the performance of the tail gate day- wagemen gains nothing
from the comparison of earnings, their wages cost per yard being over 60 per
cent above that of the tail gate rippers on incentive. In a very few cases the
ripping ...
R. G. Searle-Barnes, 1969
Truck Tail-Gate-Chain Adjustment With this chain adjustment, you can set the tail
gate of a truck at almost any height. The chains are fastened to the sides of the
truck and are inserted through strips of flat iron bolted to the ends of the tail gate.
8
11th US/North American Mine Ventilation Symposium 2006: ...
With increasing gas contents of the coal seams, it becomes necessary to bring
additional air to the tail gate end of the longwall face and the layout shown Figure
2 is often used. This layout is also necessitated because the tail-gate roads inby ...
Jan M. Mutmansky, Raja. V. Ramani, 2006
9
Principles and Practices of Modern Coal Mining
Winning of the upper layer of coal and shifting of the support system are carried
out in cycles along the total length of the face until the tail gate is reached. Then
the cutting drum of the shearer is lowered moving downwards and cutting the ...
10
Survey English Dialects
... cart-door, cartheck, cart-tail, cratch, door, end-board, end-door, end-heck,
Hacker-board, heck, heck-board, hetch, hind-board, hind-door, hind-end-board,
hinderend-door, scut, tail, tail-cratch, tail-door, tail-gate, toe-board, tumbril-board
2. n ...
