«YAWMETER» संबंधित इंग्रजी पुस्तके
खालील ग्रंथसूची निवडीमध्ये
yawmeter चा वापर शोधा. इंग्रजी साहित्यामध्ये वापराचा संदर्भ देण्यासाठी
yawmeter शी संबंधित पुस्तके आणि त्याचे थोडक्यात उतारे.
1
The Systematic Experiment
The tube is rotated through small angles until the difference between the
pressure readings is zero, at which point the yawmeter is said to be 'balanced' or '
nulled'. Provision is usually made for the angle of flow to be read off a vernier
protractor ...
2
LOCKHEED P-80 SHOOTING STAR: FLIGHT MANUAL 6
MAJOR COMPONENTS Dust Covers Data Cases and Yawmeter Installation
Group Assembly Paris list UNIT :Nälfâuäbrâßfn PART NUMBER 1 2 3 4 5 6 N °
M E N С '- ^ T U R E PER Asêv. Sëäiâë' I l l ' | l D:ust:Cov|ers,|l эфа #leises and ...
and measurements were taken at the same positions after the sea was fixed in
place. The yawmeter and stand were not altered between the tests. In the table
below are given the yawmeter readings and the changes in angle due to the sea.
A comparison of the balance results with the yawmeter results shows that for high
J below the stall the latter are too high in all cases. The correction for rotation and
contraction when applied is in the right direction to reduce the discrepancy but ...
5
National Aeronautics and Space Administration Contractor Report
And most importantly for tunnel calibrations, extreme care must be taken in
designing yawmeter supports in order to avoid inducing extraneous f low angular
i ty . The flow angle sensitivity data of Buzzell (Ref. 5), obtained with a
combination ...
United States. National Aeronautics and Space Administration, 1978
6
Technical Report of the Advisory Committee for Aeronautics ...
445. May, 1918. Summary. — (a) Introductory. (Reason for enquiry.) — The
investigation was undertaken in response to a request from the Technical
Department of the Air Board for information as to the most sensitive form of
yawmeter, and for ...
7
Calibration of transonic and supersonic wind tunnels
mechanism should be calibrated in a tunnel of size similar to which it is to be
used. And most importantly for tunnel calibrations, extreme care must be taken in
designing yawmeter supports in order to avoid inducing extraneous flow
angularity .
T. D. Reed, T. C. Pope, J. M. Cooksey, 1977
8
Fluid Measurement and Instrumentation
A THREE DIMENSIONAL YAWMETER FOR MEASURING SKIN FRICTION AND
SURFACE STREAMLINE DIRECTION IN TURBULENT BOUNDARY LAYERS L.
Gaudet, E. Savory, and N. Toy Department of Civil Engineering Fluid Mechanics
...
The yawmeter was traversed by use of a 3-axis traversing unit at the
measurement slots of x/Cx = -0.3 (almost at the middle of the spacing between
the moving bar and the blade leading edge), 1.15, l.S and 2. For convenience,
these locations ...
10
Fluid Measurement and Instrumentation, 1994: Presented at ...
A THREE DIMENSIONAL YAWMETER FOR MEASURING SKIN FRICTION AND
SURFACE STREAMLINE DIRECTION IN TURBULENT BOUNDARY LAYERS L.
Gaudet, E. Savory, and N. Toy Department of Civil Engineering Fluid Mechanics
...
Thomas B. Morrow, G. L. Morrison, Robert A. Gore, 1994
