CORSICA BUKU YANG BERKAIT DENGAN «RIDGE PIECE»
Ketahui penggunaan
ridge piece dalam pilihan bibliografi berikut. Buku yang berkait dengan
ridge piece dan ekstrak ringkas dari yang sama untuk menyediakan konteks penggunaannya dalam kesusasteraan Corsica.
The ridge end of the hip rafter may be framed against the ridge piece (Figure 2-
36) or against the ridge-end common rafters (Figure 2-37). If the hip rafter is
framed against the ridge piece, the shortening allowance is one-half of the 45-
degree ...
2
Dictionary of Architecture and Building Construction
2 see block end ridge tile. ridge gusset in timber roof construction, a fish plate for
connecting a pair of rafters at the ridge. ridge piece see ridge board. !33 ridge
plank see ridge board. !33 ridge plate in timber pitched roof construction, a piece
...
Nikolas Davies, Erkki Jokiniemi, 2008
3
Architect's Illustrated Pocket Dictionary
straight line running along the highest point of a sloping roof. ridge beam, ridge
purlin, rooftree; in timber roof construction, a horizontal timber which supports the
ends of coupled rafters at the ridge. ridge board, ridge plank, ridge piece; ...
Nikolas Davies, Erkki Jokiniemi, 2012
... than a butt joint for connecting lengths of ridge board. The joint makes it difficult
for the mating ends to slip out of position. skylights. Be sure to label each ridge
piece carefully so that all the layouts on the ridge match up with the plates below.
5
Routledge Dictionnaire Technique Anglais
... ridge heam, ridge piece, ridge plate, ridge capping, ridge tile, d'un comhle crest
falte m conste crest, ridge heam, ridge piece, ridge plate, d'un comhle ridge,
mines d'un filon apex faltière /conste ridge heam, ridge piece, ridge plate, ridge
tile ...
6
The penny cyclopædia [ed. by G. Long].
In a hipped roof, the rafters near the ends, being parallel with the others, are
necessarily diminished in length, extending from the wall-plate to the hip-rafter
instead of the ridge-piece. All such pieces, being shorter than the length between
the ...
Society for the diffusion of useful knowledge, George Long, 1841
7
The Penny Cyclopaedia of the Society for the Diffusion of ...
In a hipped roof, the rafters near the ends, being parallel with the others, are
necessarily diminished in length, extending from the wall- plate to the hip-rafter
instead of the ridge-piece. All such pieces, being shorter than the length between
the ...
Society for the Diffusion of Useful Knowledge, 1841
8
Retrospect of philosophical, mechanical, chemical and ...
A ridge is also cast at the upper part of the ridge-piece or pole, rising above the
ends of the slates, and covering also the ends of the rafters, which are bolted or
screwed to this ridge-piece. This, projecting two or three inches over the top of
the ...
We therefore added further bracing in the form of wire rope leading diagonally
from the ridge piece to fittings, (cleats, etc.) on deck—-six in all, three on each
side. We spread the cover over the framework, lashed it down and stood off to
survey ...
10
The Penny Cyclopaedia of the Society for the Difussion of ...
In a hipped roof, the rafters near the ends, being parallel with the others, are
necessarily diminished in length, extending from the wall-plate to the hip-rafter
instead of the ridge-piece. All such pieces, being shorter than the length between
the ...
Society for the Difussion of Useful Knowledge, 1841
BARANGAN BERITA YANG TERMASUK TERMA «RIDGE PIECE»
Ketahui apa yang diterbitkan oleh akhbar nasional dan antarabangsa dan cara istilah
ridge piece digunakan dalam konteks perkara berita berikut.
Maple Ridge public art answers question of Balance
The Maple Ridge piece is of grey, non-reflective aluminum with upward facing branches that end in a point. That's partly to keep the birds away, and partly to ... «Maple Ridge News, Sep 12»
