CORSICA BUKU YANG BERKAIT DENGAN «SPUR WHEEL»
Ketahui penggunaan
spur wheel dalam pilihan bibliografi berikut. Buku yang berkait dengan
spur wheel dan ekstrak ringkas dari yang sama untuk menyediakan konteks penggunaannya dalam kesusasteraan Corsica.
1
Catalogue of the Special Loan Collection of Scientific ...
Pouyer-Quertier's coupling. 561. IX.—'Ioothed-wheel Trains. 147. Spur wheels (
point-paths used for profiles). 148. Returning spur-wheel train. 149. Returning
spur-wheel train, with annular wheel. 150. Returning spur-wheel train, with
annular ...
Anon, CAMBRIDGE UNIV PR, 2011
2
Encyclopaedia Britannica: Or, A Dictionary of Arts, ...
On its axis F is a trundle of three feet diameter, having 18 rounds or staves which
fall into the cogs of the second spur-wheel B, causing it to turn round in a
direction contrary to that of the water-wheel. This second wheel is likewise 18 feet
in ...
3
A treatise of universal inland navigations: and the use of ...
sittimwheel hath contained therein eighteen rounds, so that it must make four
revolutions to one of the first spur-wheel* The second spur-wheel hath also
seventy-two cogs on its edge, and. the trundle of the water-wheel hath also
contained ...
Edmund Ronald Leach, 1791
A castor is a spur wheel intended for drawing curves and circles. The lower
section of the handle is swivelled to allow the wheel to be guided easily. An
upward embossing spur wheel is designed to produce embossed lines upward.
Polly Edman, American Foundation for the Blind, 1992
Speed of engine shaft _ No. of teeth in A x No. of teeth in H2 _ Speed of main
shaft N o. of teeth in P No. of teeth in C 10.4.3 Third Gear Here, the spur wheel G
shifts toward right and meshes with spur wheel B (as shown in Fig. 10.8 (c)).
Sudhir Kumar Saxena, 2009
I am, Sir, Yours most respectfully, Wm. Sauxdeiis. ShiHingford, Oxon. For two
wheels, say a spur-wheel of eight feet, and a nut 20 inches diameter (though it
matters not of what diameter), take a piece of three-quar- tera board, sufficient for
four ...
7
Iron: An Illustrated Weekly Journal for Iron and Steel ...
In this manner a considerable speed may be maintained on good hard level
roads for a short time ; hut by the employment of a pinion on the crank axle, and a
spur wheel on the axle of the driving wheels (which was my original proposition),
...
Sholto Percy, Perry Fairfax Nursey, 1839
8
Mechanics' Magazine and Journal of Science, Arts, and ...
A third improvement consists in placing a spur-wheel in connection with the
circular rack for the purpose of obtaining the requisite motion for tapering the
ends of the bobbins, if necessary. The claim is to the novel construction and
arrangement ...
9
Modern machine-shop practice operation, construction, and ...
Having obtained thEse arcs the curves are rolled as for a spur-wheel. A tooth
thus marked out is shown at x, and from its curves between 6 c, a template for the
large diameter of the pinion tooth may be made, while from the tooth curves ...
I am, Sir, Yours most respectfully, Wm. Saunders. Shillingford, Oxon. ' For two
wheels, say a spur-wheel of eight feet, and a nut 20 inches diameter (though it
matters not of what diameter), take a piece of three-quarters board, sufficient for
four ...
