KSIĄŻKI POWIĄZANE ZE SŁOWEM «BURET»
Poznaj użycie słowa
buret w następujących pozycjach bibliograficznych Książki powiązane ze słowem
buret oraz krótkie ich fragmenty w celu przedstawienia kontekstu użycia w literaturze.
1
Environmental Sampling and Analysis: Lab Manual - Halaman 46
Measuring pipets — Pipets that have graduation lines, much like a buret, are called measuring pipets. They are two types of measuring pipets — the Mohr pipet and the serological pipet. The difference is whether or not the calibration lines ...
2
Experiments in General Chemistry: Inquiry and Skill Building
droplets clinging to the buret walls. If you observe droplets, you must clean the buret thoroughly. Various special cleaning mixtures are sometimes employed, but most of these are dangerously corrosive. It is recommended that for cleaning a ...
Vickie Williamson, Larry Peck, 2013
3
Analytical Chemistry for Technicians, Fourth Edition - Halaman 74
Another piece of glassware often used in titrimetric analysis (for both standardization experiments and sample analyses) is the buret. A traditional glass buret (Figure 4.3) is a long and narrow graduated cylinder with a dispensing valve at the ...
4
Methods of Air Sampling and Analysis - Halaman 44
6.4.1 Use of the Buret. The buret is thoroughly cleaned before use. If the buret has a glass stopcock, it should be greased with stopcock grease, not petrolatum, so that it is well lubricated and the capillary tip allows the liquid to flow freely.
James P. Lodge, Jr., 1988
5
Chemical Principles in the Laboratory - Halaman 42
Obtain a buret, a 100 mL volumetric flask containing your concentrated unknown chloride solution, and a 10 mL volumetric pipet. USING CARE, add distilled water slowly to the volumetric flask up to the mark on the narrow neck, squeezing ...
Emil Slowinski, Wayne Wolsey, Robert Rossi, 2015
The Buret Obtain a buret and set it up in a clamp on your lab bench. Fill the buret with tap water, and check to make sure that there are no leaks from the stopcock before proceeding. If the stopcock leaks, have the instructor examine the ...
Steven Zumdahl, Susan Zumdahl, 2013
7
Laboratory Manual for Human Biology
Fill about three-quarters of the reservoir of the upper buret with water. Imagine that this is drinking water, which, after you drink it, adds to the body fluid volume. 2. Pour 100 mL of acid buffer solution into a 1-L Er- lenmeyer flask and place it ...
David Morton, Joy B. Perry, James Perry, 2011
8
Food Analysis: Principles and Techniques (In 4 Volumes) - Halaman 81
Buret A is filled with mercury from bulb B by adjusting the level of B, and stopcock D is closed. The two absorption flasks are immersed into the bath and when the system attains thermal equilibrium, the absorption flasks are connected to the ...
9
Laboratory Manual for Principles of General Chemistry - Halaman 30
A clean buret in conjunction with the proper technique for measuring and dispensing a C. Titrating a 1. Titrant: the reagent solution in the buret to be used for the experiment Record the volume: To record the correct number of significant figures ...
10
Rapid Analysis of Silicate, Carbonate and Phosphate Rocks
Turn the stopcocks on the buret (B) (fig 9), and on the absorption pipet (O) so that the channel is open between them. Adjust the level of thc KOH in the absorption pipet (C) to the reference line by raising or lowering the leveling bulb (D), and ...
Leonard Melvyn Shapiro, Walter Wallace Brannock, 1962
