CĂRȚI ÎN ENGLEZĂ ÎN LEGĂTURĂ CU «SCLEROMETRIC»
Descoperă întrebuințarea
sclerometric în următoarea selecție bibliografică. Cărți în legătură cu
sclerometric și extrase din aceasta pentru a furniza contextul de întrebuințare al acestuia în literatura Engleză.
4.2.2 - Interface failure in sclerometric wear testing For all samples tested under
the blunt diamond and WC riders the loading becomes Hertzian after a few initial
passes and no detectable weight loss is seen. This corresponds to a situation of ...
D. Dowson, C.M. Taylor, M. Godet, 1990
2
Science and Technology for the Conservation of Cultural Heritage
The petrophysical characterization was done using ultrasonic wave propagation
velocity (Vp)-taking into account the indirect transmission method (in the field)
and the direct transmission method (in the laboratory)-, using the sclerometric ...
Miguel Angel Rogerio-Candelera, Massimo Lazzari, Emilio Cano, 2013
3
Lubrication at the Frontier: The Role of the Interface and ...
This second part describes some results about fluids influence on the abrasion
test of sintered alumina This influence is studied starting fiom the evolution of the
sclerometric parameters according to their nature. The selected fluids were tested
...
M. Priest, P. Ehret, L. Flamand, 1999
4
Structural Studies, Repairs and Maintenance of Heritage ...
The round columns have returned values of the sclerometric bounce index (
average value of the ten measurements for each point) between 35.55 and 39.35
uniformly distributed on the surface (i.e. independently of the number of the ...
5
Soviet Journal of Optical Technology
Sclerometric tests, conducted on K8, LK5, STK9, TF2 and BF6 glasses, showed
that the addition of glycerine, trieth- anol amine and a surface-active emulsion to
water leads to a decrease of the sclerometric hardness Ha and the transient ...
6
Journal of the Institute of Metals
The varying reflection of neighbouring grains evidently depends on the different
sclerometric hardness of metallic crystals along different crystallographic axes,
and it is not necessary that a second phase should present, although in a ...
7
Limestone in the Built Environment: Present-day Challenges ...
The mean sclerometric surface hardness results obtained for the materials are
given in Table 4. The values shown for palomera stone refer to the
measurements taken on ashlars and the uncarved areas at the rear of the
arabesques, as the ...
8
The Conservation and Structural Restoration of Architectural ...
4.3.5 Sclerometric and penetration test The sclerometric test provides a way of
measuring the hardness of materials such as concrete and some types of brick or
stone. The strength of mortar can be calculated on the basis of the resistance ...
9
ECCM-8: European Conference on Composite Materials ; ...
Microsismic sclerometric and compression tests on cores were carried out in
order to evaluate the concrete properties. Tests results are reported in tables 1
and 2. Table 1 Results of compression tests Table 2 Results of miurosismic and ...
I. Crivelli Visconti, 1998
10
The Influence of Temperature on the Mechanical Properties of ...
This law was first applied by Mendeleyev in 1898 to determine material hardness
; to this end he built several versions of sclerometric pendulums (Fig. 1) [6]. These
devices are in the Mendeleyev Museum. Twenty-five years later an English ...
Evgeniĭ Mikhaĭlovich Savit͡skiĭ, 1961
