CĂRȚI ÎN MALAEZĂ ÎN LEGĂTURĂ CU «VERNIER»
Descoperă întrebuințarea
vernier în următoarea selecție bibliografică. Cărți în legătură cu
vernier și extrase din aceasta pentru a furniza contextul de întrebuințare al acestuia în literatura Malaeză.
1
Handbook of Dimensional Measurement - Halaman 21
however, be considered equivalent substitutes for snap gages, primarily because the setting accuracy of a vernier caliper is inferior to the gage maker tolerances to which snap gages are made. The locking screw should be on the top side of ...
Francis T. Farago, Mark A. Curtis,
1994
2
Physics Lab Manual - Halaman 25
Vernier Zero Mark 2 3 Alignment of vernier with fixed scale Figure 2-3 Illustration of vernier caliper reading of 2.06 cm. The caliper has marked on the main scale major divisions of 1 cm for which there are both a mark and a number. On the ...
3
The Surveying Handbook - Halaman 152
The telescope bubble is then brought to center using the bubble-tube adjusting nuts or screws. Check by repeating the peg test. Vertical Vernier The purpose of this adjustment is to ensure that the vertical vernier is reading exactly 0°, when the ...
Russell Charles Brinker, Roy Minnick,
1995
4
Comprehensive Basic Mechanical Engineering - Halaman 102
closing them together tightly and setting them to 0-0 point of the main and vernier scales. In this position, the caliper is held against a light source. If there is wear, spring or warp, a knock-kneed condition as shown in Fig. 3.25 (a) will be ...
5
The World of Physics - Halaman 58
If, however, we need to measure the thickness of a wire of about 1 mm diameter (to be used in a resistivity experiment) we can choose between a ruler, a vernier caliper and a micrometer screw gauge. All these instruments would give a ...
6
Shop Reference for Students and Apprentices - Halaman 186
is contained within the movable jaw and permits the vernier caliper to measure to within 0.00 1 or 0.02 mm. Some types of vernier calipers also have a fine adjustment slide to aid in making accurate measurements. The major variations of the ...
Edward G. Hoffman, Christopher J. McCauley, Muhammed Iqbal Hussain,
2001
7
Engineering Drawing - Halaman 4-20
The vernier or vernier scale is an auxiliary scale. It slides across a fixed main scale, by which a uniformly graduated main scale can be accurately read to a fractional part of a division. It can be used on any measuring device with a graduated ...
8
Surveying Instruments - Halaman 83
accuracies are nowadays replaced by optical one,-. ,»uch as line microscope, scale- and vernier microscope, optical vernier, and optical estimation (douhle circle reading), .simple optical micrometers, and micrometers with automatic means.
9
How It Works: Science and Technology - Halaman 2582
A A vernier gauge on a microscope stage- each division is 0.9 of the main-scale divisions. The measurement indicated here is exactly 120, because it is the zero mark on the vernier that is aligned with the main-scale marking. SEE ALSO: ...
Marshall Cavendish Corporation Staff,
2003
10
Surveying - Halaman 65
Circle reading devices are primarily built as vernier or reading microscopes. Only very primitive instruments have a simple line index with a magnifying glass. The type of reading device influences the structure and accuracy of the theodolite.
Heribert Kahmen, Wolfgang Faig,
1988