КНИГИ НА АНГЛИЙСКИЙ ЯЗЫКЕ, ИМЕЮЩЕЕ ОТНОШЕНИЕ К СЛОВУ «THREE JAW CHUCK»
Поиск случаев использования слова
three jaw chuck в следующих библиографических источниках. Книги, относящиеся к слову
three jaw chuck, и краткие выдержки из этих книг для получения представления о контексте использования этого слова в литературе на английский языке.
K. L. Narayana. nut from the stud 5. It may further be noted that the work piece is
machined at the required surface before loading in the jig. This is so, because,
certain machined surfaces of the work piece may be used for locating it in the jig.
2
Precision Machining Technology
FIGURE 5.2.5 Round and hexagonal workpieces can be properly secured in a
three-jaw chuck. The three-jaw chuck is ideal for holding workpieces that are
either round or that have a number of flat sides that is divisible by three.
Examples of ...
Peter Hoffman, Eric Hopewell, Brian Janes, 2014
By grinding a tap or other round-shank tool on three sides as shown in the
drawing, it can be held in a three-jaw chuck without slipping. In grinding, the
squared end of the tap is, of course, not touched, but the metal is removed on the
round ...
4
Fundamentals of Metal Cutting and Machine Tools
The chucks are of two types i.e. three jaw chuck and four jaw chuck. (a) 3-Jaw
chuck (b) Collet chuck (c) Face plate Fig. 1 .4 - Some Work Holding Devices In
the three-jaw chuck, the jaws are made to move simultaneously and equally in ...
B. L. Juneja, Nitin Seth, 2003
5
Manufacturing Technology - II
Three jaw chuck is not suitable for unsymmetrical leccemrlcall Componems'
Figure 2.28 3 Jaw Self Centering Chuck (b) Four jaw independent chuck ' ' '
concentric It Is used for holding complex and asymmetrical shaped ewes
workpieces. it ...
Dr. R.Kesavan, B. Vijaya Ramanath, 2006
6
Manufacturing Technology: Metal cutting and machine tools
Of these, the three-jaw chuck or the self-centering chuck, as shown in Fig. 4.4, is
the most common one. The main advantage of this chuck is the quick way in
which the typical round job is centred. All the three jaws would be meshing with
the ...
Posinasetti Nageswara Rao, 2013
7
FCS Fitting and Turning L2
The two types of chucks that you use on the lathe are the three-jaw chuck and the
four-jaw chuck. A three-jaw chuck can hold round and hexagonal work pieces.
When the chuck is closed by turning the chuck key, the three jaws all move at the
...
Jenny Schnetler, Salie Majiet, 2007
8
Manufacturing Processes - I
In a three-jaw chuck, all the jaws close in together, actuated by the spiral groove
cut on the face of a flat disc, called a scroll. Their principle of operation is similar
to that of a screw, except that the screw is cut on the face. It is easy to operate and
...
9
ELEMENTS OF MANUFACTURING PROCESSES
Three-jaw chuck. In a three-j aw chuck, all the jaws are made to slide
simultaneously by an equal amount within the slots provided on the body by
rotating any one of the three pinions with the help of a handle. Figure 5.4(a)
shows a three-jaw ...
B. S. NAGENDRA PARASHAR, R. K. MITTAL, 2002
(a) Three jaw chuck Body It is a self centering chuck. It is used for holding
symmetrical workpieces. It has three jaws and all three jaws move towards the
centre on a scroll arrangement, as shown in fig. 2. 24. Jaw The centering and
gripping of ...
