«YIELD POINT» தொடர்புடைய ஆங்கிலம் புத்தகங்கள்
பின்வரும் புத்தக விவரத்தொகுப்புத் தேர்ந்தெடுப்பில்
yield point இன் பயன்பாட்டைக் கண்டறியுங்கள்.
yield point தொடர்பான புத்தகங்கள் மற்றும் ஆங்கிலம் இலக்கியத்தில் அதன் பயன்பாட்டுச் சூழலை வழங்குவதற்கு அதிலிருந்து பெறப்பட்ட சுருக்கமான சாரங்களைத் தொடர்புபடுத்துகின்றன.
1
Atlas of Stress-strain Curves
Some curves exhibit a definite yield point, while others do not. When the stress
exceeds a value corresponding to the yield strength, the specimen undergoes
gross plastic deformation. If the load is subsequently reduced to 0, the specimen
will ...
2
The Rheology Handbook: For Users of Rotational and ...
a) The rod remains standing in the hand cream: Thus, a yield point exists. b) The
rod moves very slowly to the side: although the silicone has a very high flow
resistance it has no yield point, i.e. it has the character of a highly viscous
polymeric ...
3
Characterization and Failure Analysis of Plastics
Figure 4 shows the effect of pressure on the yield point. Under a multiaxial stress
field, a modification of either the Tresca or the von Mises criterion is applicable.
The modified Tresca criterion is given by: 2 τ y μP (Eq 20) and the modified von ...
ASM International, Steve Lampman, 2003
There are three common definitions of yield strength: ○ Offset yield strength ○
Extension-under-load (EUL) yield strength ○ Upper yield strength (or upper yield
point) An upper yield strength (upper yield point) (Fig. 7a) usually occurs with ...
5
Elements of Metallurgy and Engineering Alloys
3.11 Interstitial atmospheres in crystal lattice yield point, is often observed in low-
carbon steels. Yield-point reductions on the order of 30% are common. The
stress initially rises in a uniform fashion until it reaches point a, known as the
upper ...
The dependence on the upper yield strength (o^uyp) and the yield point drop (or
the difference between (Tuyp and the lower yield point, a lyp) on grain size, d,
has been investigated by Hutchison, t Fetch,* and WorthingtonB relative to Armco
...
7
Introduction to Engineering Materials
Point A is termed the upper yield point. The stress level necessary to continue
plastic straining falls to level B, the lower yield point, and a considerable amount
of plastic strain takes place at this lower level. After this sudden yielding has ...
8
Metal Fabricator's Handbook
STRESS, YIELD POINT, TENSILE STRENGTH & ELONGATlON Terms you
should be familiar with I needed to form a small-diameter, deep dome to clear. To
choose a material, be it aluminum, steel or whatever, you need an understanding
of ...
Ron Fournier, Sue Fournier, 1990
9
Properties of Crystalline Silicon
In the early years special emphasis was placed on the yield point and its
correlation to dislocation dynamics. A comprehensive review of this period was
given by Alexander and Haasen [1]. Results of subsequent work were collected
by ...
10
Modern Physical Metallurgy and Materials Engineering: ...
Science, Process, Applications R. E. Smallman, Ray J. Bishop. Strain - • e (a) (b)
Figure 7.24 Schematic representation of (a) strain ageing and (b) Liiders band
formation. Figure 7.27 Development of a yield point with ageing at.
R. E. Smallman, Ray J. Bishop, 1999
«YIELD POINT» வார்த்தையைக் கொண்டுள்ள புதிய உருப்படிகள்
பின்வரும் செய்தி உருப்படிகளின் சூழலில்
yield point என்ற வார்த்தையைப் பயன்படுத்துவது பற்றியும் எப்படிப் பயன்படுத்துவது என்பதைப் பற்றியும் தேசிய மற்றும் பன்னாட்டு அச்சகங்கள் என்ன பேசியிருக்கின்றன என்பதைக் கண்டறியுங்கள்.
Chevron Stock At The Magic 4% Yield Mark (CVX)
If you bought at a 4% yield point in 1978, you went on to compound your wealth at 12.3% annually. If you bought at the 4% yield point in 1985, you went on to ... «Seeking Alpha, மார்ச் 15»
இல் உள்ள வார்த்தைகளில் மறைக்கப்பட்டிருக்கும் எல்லாவற்றையும் கண்டறியுங்கள் 
