«SHUTTLE ARMATURE» İLE İLİŞKİLİ İNGILIZCE KİTAPLAR
shuttle armature sözcüğünün kullanımını aşağıdaki kaynakça seçkisinde keşfedin.
shuttle armature ile ilişkili kitaplar ve İngilizce edebiyattaki kullanımı ile ilgili bağlam sağlaması için küçük metinler.
1
Dynamo Construction: A Practical Handbook for the Use of ...
Siemens' Shuttle Armature. — The shuttle form of armature, previously mentioned
, was re-invented by Werner Siemens, of Berlin, and patented in England in 1856
.* It was at first used mainly for telegraphic purposes, in magneto machines of ...
2
Dynamos and Electric Motors: How to Make and Run Them ...
Centre Stampings for Laminated Shuttle Armature. Fig. I.-- End Stampings for
Laminated Shuttle Armature. six to sixteen, and the number of coils is determined
by the number of spaces between the cogs. Fig. 8 shows in section a shuttle or ...
Paul Nooncree Hasluck,
1897
3
The Model Engineer and Amateur Electrician: A Journal of ...
Siemens was making small dynamos having his well-lmown H or shuttle
armature. Shortly after Gramme had established the reputation of his machines,
von Hefner Alteneck developed the single coil shuttle armature into the multi-coil
drum ...
4
Dyke's automobile and gasoline engine encyclopedia
To time an inductor type armature, place rotors just the same as a shuttle
armature. Fig. 4. The K. W. Inductor Type of Low Tension Magneto, used with a
master vibrator in connection with dry cr-lls as a source 0! supply for starting.
Chart 120 ...
5
Physics for Secondary Schools
Such an armature is called a shuttle armature. 518. The drum armature, which
was developed from the shuttle armature, is one very much used in direct current
dynamos. Instead of one coil in one pair of grooves, there are several coils in as ...
Charles Francis Adams,
1908
6
Lessons in practical electricity: principles, experiments, ...
313 illustrates a Siemens shuttle armature, which is revolved between the poles
of Cross-section of Shuttle Armature. the permanent magnets, NS, and called a
magneto generator, because the field is produced by permanent magnets.
Coates Walton Swoope,
1901
7
Dyke's Automobile and Gasoline Engine Encyclopedia
Note the inductors revolve between the magnet poles, just the same as the
shuttle armature core. Therefore the same principle applies here as explained on
pages 249 and 266. The Interrupts: or Contact Breaker is used in connection with
this ...
In the above-mentioned figures a shuttle armature, a, is shown, mounted in gun-
metal bearings, concentrically with soft iron polar exten- ny k sions, P, P1. The
latter pieces, which serve to distribute the magnetic field, are enclosed by the
legs ...
Now this small current which flows through the fine wire winding of the pole
pieces and through the shuttle armature of the automatic switch is not strong
enough to cause the switch F to be closed against the pull of the spring. Although
C, is ...
Procure castings for a Kapp or over-type form of field, with cores 8 in. in height, 6
in. in length, and 1 in. in thickness, and a laminated drum or shuttle armature 3 in.
in diameter and 0 in. long. A shuttle armature is easier to wind, but more current ...
Paul Nooncree Hasluck,
1905