与 «COERCIMETER»相关的英语书籍
在以下的参考文献中发现
coercimeter的用法。与
coercimeter相关的书籍以及同一来源的简短摘要提供其在 英语文献中的使用情境。
1
Springer Handbook of Metrology and Testing
Coercimeter. The size and shape of soft magnetic components often makes it
impossible to measure the complete hysteresis loop. In this case a coercimeter
can be used to determine the coercivity HCJ. As this quantity depends sensitively
on ...
Horst Czichos, Tetsuya Saito, Leslie E. Smith,
2011
2
Springer Handbook of Materials Measurement Methods
10.2.3.2.1 Coercimeter The size and shape of soft magnetic components often
makes it impossible to measure the complete hysteresis loop. In this case a
coercimeter can be used to determine the coercivity HcJ. As this quantity
depends ...
Horst Czichos, Tetsuya Saito, Leslie Smith,
2006
3
The Soviet Journal of Nondestructive Testing
(2) The coercimeter readings are practically constant and dependent mainly on
the coercive force of the nonhardened core (in Fig. 1 this section is shown on a
larger scale than the others). The initial magnitude of the case, from which
onward ...
Wagner turbi(lin1eter.“ Cooke short-column elutriator." Sedimentation balance."
Solubility rate (quartv.)." Flow meter.” Each of these methods has its merits-and
limitations. For instance. the coercimeter is not adaptable to nonmagnetic
powders, ...
5
Magnetic Separation of Ores
Even 4-inch lengths of round %-inch tool -steel rods showed a slight difference,
measurable on the coercimeter, at the ends entering the quenching water first
and last. The idea of determining coercive force by drawing a secondary coil over
a ...
Reginald Scott Dean, Charles Wesley Davis,
1941
6
Introduction to Magnetism and Magnetic Materials, Second Edition
The magnetometers used with the technique are often fluxgates (also known as
ferroprobes), but Hall probes and induction coils are also used and in cases
where the coercivity needs to be measured, a coercimeter is used. A coercimeter
...
7
Metallurgical Division progress reports
To realize "both of these capabilities, a means largely independent of the design
of the coercimeter proper must be used to attain the necessary sensitivity. The
additional requirement of an independent means for producing high magnetic ...
R. S. Dean, United States. Bureau of Mines. Metallurgical Division,
1938
8
Bulletin. Technical Series
THE COERCIMETER AND MATERIAL USED The coercimeter, as its name
implies, is an instrument for measuring the coercive force* of magnetic
substances. It was developed by Davis and Hartenheim. The coercimeter is
shown in Figure 17, ...
University of Missouri. School of Mines and Metallurgy,
1935
Use of the Coercimeter in Grinding Tests By Fred D. DeVaney and Will H. Coghill
* (New York Meeting, February, 1938) The coercimeter, as its name implies, is an
instrument for measuring the coercive force t of magnetic substances.
10
Characterization and Measurement of Magnetic Materials
... 27, 33(t) measurement, 338-340, 479, 486, 498(f), 513(f) temperature
coefficient in permanent magnets, 479 Coercimeter, 338-340 Coherent units, 613
Cold / hot rolling of magnetic steels, 35(t), 40(t), 45(t) Compensated
permeameters, 314, ...