与 «FEEDHOLE»相关的英语书籍
在以下的参考文献中发现
feedhole的用法。与
feedhole相关的书籍以及同一来源的简短摘要提供其在 英语文献中的使用情境。
1
4th European Conference of the International Federation for ...
lack of a significant difference between the two investigated feedhole geometries
with 50 um and 200 um feedhole width. Independent of cathode feedhole size,
the anodes show no indication of increased polarization due to insufficient ...
Jos van der Sloten, Pascal Verdonck, Marc Nyssen, 2009
2
From Coal Oil Lights to Satellites
While all this was going on, Nels and John forked some sheaves away from the
straw and piled them near the feedhole. The engine started, and the mill shook
as it gained speed once more. Floyd directed the blower toward where it had
been ...
3
Analyzing fuel systems technology for fuel economy and emissions
There are two geometries that can be altered, the feedhole cavity and the
feedhole. Figure 13 shows a cross Feedhole Seat A Feedhole cavity t F dh ee ole
cavity depth Figure 13: Cross sectional view of the seat showing the feedhole
and the ...
Society of Automotive Engineers, 1996
4
Fundamentals of Tribology
C B A Feedhole resistance Oil film resistance 0 = p Fig. 9.3. Hydrostatic bearing
circuit resistances. The bearing composes a circular disc capable of rotating
about its spin axis under a load, W. There is a deep recess on the bottom face
above ...
Ramsey Gohar, Homer Rahnejat, 2008
An open feedhole in the crownboard goes some way towards overcoming these
troubles by allowing the moist, warm, air given off by the cluster to escape into the
roof cavity and out through the vents. The open feedhole system is, however, ...
6
A Course in Mathematical and Statistical Ecology
The radius of each feedhole varies from 0.15 to 1 milimeter. Through these
feedholes the air is transported into the bearing gap from the compressor. The
pressure of the air from the compressor is about 0.4-0.7 Mpa. Other bearings
have a ...
Anil Gore, Sharayu Paranjpe, 2000
With the lubricant feedhole placed in the unloaded portion of the bearing gap, the
inlet film would be formed not too far from the maximum gap. While it is realized
that the inlet location would vary somewhat depending on the specific feeding ...
8
Journal of Lubrication Technology
With the lubricant feedhole placed in the unloaded portion of the bearing gap, the
inlet film would be formed not too far from the maximum gap. While it is realized
that the inlet location would vary somewhat depending on the specific feeding ...
Under hand-firing each feedhole is used, while in mechanical firing it is the usual
practice to use alternate rows only. The feedhole rows not used for firing are used
for observation purposes and the ordinary hand-firing passages are still left ...
10
Good Bee-keeping, a Monthly Magazine Devoted to Practical ...
This, I judge, is better than leaving the feedhole for ventilation open or, as the
latest bulletin on bee-hives tells us, keep an empty super of combs over the
brood nest for wintering. This may be all right, but it increases the size of the
brood nest ...
