与 «HALF-ROUND CHISEL»相关的英语书籍
在以下的参考文献中发现
half-round chisel的用法。与
half-round chisel相关的书籍以及同一来源的简短摘要提供其在 英语文献中的使用情境。
1
MECHANICAL WORKSHOP PRACTICE
The half round chisel is also known as round nose chisel. The length of the chisel
varies from 150 to 250 mm. There are cold chisels of various shapes other than
the specified above and they are made to suit the special requirement.
The Half-Round Chisel: This is similar to the diamond-point chisel, the difference
being in the cutting edge. The half-round chisel has a round cutting edge and is
therefore used for cutting round grooves or for trimming fillets. All cold chisels are
...
3
Metalwork for Primary Schools: Standard 6, 7 and 8
Half-round Chisel (Round Nose Chisel) This type of chisel is used for: (a) Cutting
circular grooves. (b) Pulling over off-set drilled holes. The shape of the cutting
edge is almost semi-circular and the metal and heat-treatment is the same as for
...
4
Engineering GNVQ: Intermediate
Cutting edge slightly curved Flat chisel Cross cut chisel Half round chisel All
chisels shown have octagonal shanks Diamond point chisel (a) Types of chisel (1
) Break down surface into strips with cross cut chisel Cutting an oil groove with a
half ...
5
Engineering Fundamentals
Cutting edge slightly curved Flat chisel Cross cut chisel All chisels shown have
octagonal shanks Half round chisel (a) Break down surface Diamond point chisel
(b) into strips with cross cut chisel Break down strips with flat chisel that is slightly
...
6
Fabrication and Welding Engineering
Cutting edge slightly curved Flat chisel Cross cut chisel All chisels shown have
octagonal shanks Half round chisel (a) Diamond point chisel Break down surface
into strips with cross cut chisel Break down strips with flat chisel that is slightly ...
465 GOODELL-PRATT Pin Punch Cold Chisel Cape Chisel Half Round Chisel
Solid Punch Cup Punch Prick Punch No. 466 Center Punch No. 474 Double End
Wrench No. 475 Double End Wrench No. 476 Double End Wrench No.
The ends are shaped with the half-round chisel and diamond point. Sand if
necessary. Remove from lathe and cut off waste portions. 4. Next, mount a block
in the lathe and turn both handles. Turn the handles using a gouge, skew, half-
round ...
9
Agricultural Engineering in Development: Basic Blacksmithing ...
It is used with a hand hammer for cutting both hot and cold metal. FIGURE 12. /Q.
£^. cr. HOT CHISEL. d. COLD CHISEL HALF-ROUND CHISEL FIGURE 12A
TONGS The blacksmith uses many different types and styles of. Basic
blacksmithing.
10
Boxes for the Protection of Books: Their Design and Construction
... 2-2, 2-A, 2-11 Creasing machine (creaser). 1-6, 1-17, 3-5, 3-12, 3-15 Filler
blocks and boards . 1-4,5-7,6-11,7-11 Grain of materials 1-8 Half-round chisel 1-
17-18, 3-5, 3-12 Heat sealer 1-7, 1-17-18, 2-2, 2-8 Hinged shelf 5-35-39 Jog box
...
