与 «SAW-OFF»相关的英语书籍
在以下的参考文献中发现
saw-off的用法。与
saw-off相关的书籍以及同一来源的简短摘要提供其在 英语文献中的使用情境。
1
Jim Tolpin's Table
Saw Magic
But it should not be so accessible that it can be accidentally turned on by
brushing up against it. Stand in front of the saw as though you were making a cut
and ask yourself which hand you would use if you had to turn the saw off in a
hurry.
2
A Navajo/English Bilingual Dictionary: Áłchíní Bi Naaltsoostsoh
Singular (one person) T'ahdii - present I saw off you saw off she/he saws off one
saws off Dual Plural (two people) we saw off you saw off they saw off people saw
off Distributive Plural (three or more people) we saw off you saw off they saw off ...
3
Debates: Official Report
My hon. friend has stated that there Is a saw-off between the two sides of this
House. Although I refer to this again I would have supposed that there would not
have been any necessity to do so In the face of the denial twice repeated of my
hon.
Canada. Parliament. House of Commons, 1907
4
Official gazette of the United States Patent Office
In a saw-table for a rail-mill, the combination with a saw adapted to saw off the
ends of a rail lying upon said table, of a set of clamps adapted to engage with
said rail as it lies upon the table and straighten the same in a given plane, a
second ...
United States. Patent Office, 1899
5
The Southwestern Reporter
D. B. Bostick testified: "I am general foreman of the defendant. * * * B. D. Browan
had charge of the gang that was doing that work. * • ♢ Where wires go through the
limbs of a tree it is our custom to saw off limbs that may endanger the wires or ...
Meant as a practical guide for the aspiring hippie, Steal This Book captures Hoffman's puckish tone and became a cult classic with over 200,000 copies sold.
Abbie Hoffman, Izak Haber, Bert Cohen, 2002
Practice with the saw off. • Never stand on the inside of the cut. • Never tie the
saw to the cutter or to anything that restricts total freedom of movement. Lying on
the bottom of the lake for a few hours will not hurt the saw. Equipment means ...
Walt Hendrick, Andrea Zaferes, 2003
8
Industrial-arts Magazine
3. Make necessary measurements and turn field upside down in vise. 4. Bend
ends back at right angles to form feet. 5. Drill necessary holes for screws and
magnet core. 6. Saw off one inch piece of gas pipe and file ends to make them
square.
9
Industrial Arts and Vocational Education
Saw off one inch piece of gas pipe and file ends to make them square. 7. Saw off
1%" piece of 3/16” iron rod. Magnet Coil Washers. 8. Rivet field together, using
the iron rod for 1. Draw a circle 1%” in diameter on the fibre. rivet. 2. Bore out the
...
(Cut off 1' 6” for bottom rail, rip up center of remainder for stiles, top and lock rails.
) 1 piece 1}”x10"x5' 6” (for panels). Bracket. 1 piece 1"x6”x8' 0”. Saw off. 4' 2” and
rip for sides, then saw off 2' 4" for top and bottom rails, the remaining piece will ...
