与 «STALAGMOMETER»相关的英语书籍
在以下的参考文献中发现
stalagmometer的用法。与
stalagmometer相关的书籍以及同一来源的简短摘要提供其在 英语文献中的使用情境。
1
Applied Chemistry : Theory And Practice
-X A - Wide-mouth receiving bottle B - Tightly fitting rubber stopper C -
Stalagmometer D - Glass tube E - Rubber tubing K - Screw-pinch-cock G -
Thermostat H - Liquid under test I - Clamp TI - Thermometer Procedure
Thoroughly dean the ...
2
College Practical Chemistry
9.5 Stalagmometer with a sharp flat ground glass end should know the number of
drops produced from equal volumes of two liquids and the densities of the two
liquids. In addition to this, surface tension of water (one of the liquids) should also
...
V K Ahluwalia, Sunita Dhingra, Sunita Dhingra, 2005
3
40 CFR Protection of Environment: CFR Parts ...
2.2 This method determines the surface tension of the bath using a
stalagmometer or a tensiometer to confirm that there is sufficient wetting agent
present. 3.0 Definitions [Reserved] 4.0 Interferences [Reserved] 5.0 Safety 5.1
Disclaimer.
Office of The Federal Register, 2014
Method II : Stalagmometer method : (Drop-weight method) : A stalagmometer is
essentially a pipette having flattened lower tip. The upper and lower stems are
graduated. (Fig. 8.5). The stalagmometer is held in a vertical position and liquid is
...
5
Advanced Practical Physical Chemisty
tubing with a screw clip is not available, the rate of formation of drop can be
regulated by putting the tip of the fore finger on the top of the stalagmometer and
regulating the entry of air into it. The capillary serves for slowing down the flow
rate ...
6
Practical Physical Pharmacy & Physical Pharmaceutics
AIM : To determine, the surface tension and parachor values of given liquids at
R.T. using a stalagmometer. Calculate the parachor of CH2. APP. CHEMICALS :
Stalagmometer, benzene, toluene, xylene. DEFINITION : Surface tension is ...
7
The Code of Federal Regulations of the United States of America
2.2 This method determines the surface tension of the bath using a
stalagmometer or a tensiometer to confirm that there is sufficient wetting agent
present. 3.0 Definitions. [Reserved] 4.0 Interferences. [Reserved] 5.0 Safety 5.1
Disclaimer.
8
L.S.A., List of C.F.R. Sections Affected
2.2 This method determines the surface tension of the bath using a
stalagmometer or a tensiometer to confirm that there is sufficient wetting agent
present. 3.0 Definitions. [Reserved] 4.0 Interferences. [Reserved] 5.0 Safety 5.1
Disclaimer.
9
Code of Federal Regulations, Title 40, Protection of ...
2.2 This method determines the surface tension of the bath using a
stalagmometer or a tensiometer to confirm that there is sufficient wetting agent
present. 3.0 Definitions [Reserved] 4.0 Interferences [Reserved] 5.0 Safety 5.1
Disclaimer.
Office of the Federal Register, 2010
10
Colloid and Surface Chemistry: A Laboratory Guide for ...
Drop weight (stalagmometer) The measurement principle of a stalagmometer
uses the relationship between the weight of a drop of liquid and its surface
tension. Stalagmometer is a vertically placed glass tube with a wide liquid
compartment ...
Seyda Bucak, Deniz Rende, 2013