Signification de "unsolder" dans le dictionnaire anglais

PRONONCIATION DE UNSOLDER EN ANGLAIS

unsolder  [ʌnˈsəʊldə]

CATÉGORIE GRAMMATICALE DE UNSOLDER

Unsolder est un verbe.

Le verbe, c'est la partie de la proposition que l'on conjugue et qui décrit l'action et l'état.

Voir la conjugaison du verbe cantar en anglais.

QUE SIGNIFIE UNSOLDER EN ANGLAIS

définition de unsolder dans le dictionnaire anglais

La définition de unsolder dans le dictionnaire est de supprimer la soudure de quelque chose.

CONJUGAISON EN ANGLAIS DU VERBE UNSOLDER

PRESENT

Present

I unsolder

you unsolder

he/she/it unsolders

we unsolder

you unsolder

they unsolder

Present continuous

I am unsoldering

you are unsoldering

he/she/it is unsoldering

we are unsoldering

you are unsoldering

they are unsoldering

Present perfect

I have unsoldered

you have unsoldered

he/she/it has unsoldered

we have unsoldered

you have unsoldered

they have unsoldered

Present perfect continuous

I have been unsoldering

you have been unsoldering

he/she/it has been unsoldering

we have been unsoldering

you have been unsoldering

they have been unsoldering

PAST

Past

I unsoldered

you unsoldered

he/she/it unsoldered

we unsoldered

you unsoldered

they unsoldered

Past continuous

I was unsoldering

you were unsoldering

he/she/it was unsoldering

we were unsoldering

you were unsoldering

they were unsoldering

Past perfect

I had unsoldered

you had unsoldered

he/she/it had unsoldered

we had unsoldered

you had unsoldered

they had unsoldered

Past perfect continuous

I had been unsoldering

you had been unsoldering

he/she/it had been unsoldering

we had been unsoldering

you had been unsoldering

they had been unsoldering

FUTURE

Future

I will unsolder

you will unsolder

he/she/it will unsolder

we will unsolder

you will unsolder

they will unsolder

Future continuous

I will be unsoldering

you will be unsoldering

he/she/it will be unsoldering

we will be unsoldering

you will be unsoldering

they will be unsoldering

Future perfect

I will have unsoldered

you will have unsoldered

he/she/it will have unsoldered

we will have unsoldered

you will have unsoldered

they will have unsoldered

Future perfect continuous

I will have been unsoldering

you will have been unsoldering

he/she/it will have been unsoldering

we will have been unsoldering

you will have been unsoldering

they will have been unsoldering

CONDITIONAL

Conditional

I would unsolder

you would unsolder

he/she/it would unsolder

we would unsolder

you would unsolder

they would unsolder

Conditional continuous

I would be unsoldering

you would be unsoldering

he/she/it would be unsoldering

we would be unsoldering

you would be unsoldering

they would be unsoldering

Conditional perfect

I would have unsolder

you would have unsolder

he/she/it would have unsolder

we would have unsolder

you would have unsolder

they would have unsolder

Conditional perfect continuous

I would have been unsoldering

you would have been unsoldering

he/she/it would have been unsoldering

we would have been unsoldering

you would have been unsoldering

they would have been unsoldering

IMPERATIVE

Imperative

you unsolder
we let´s unsolder
you unsolder

NONFINITE VERB FORMS

Infinitive

to unsolder

Past participle

unsoldered

Present Participle

unsoldering

TRADUCTION DE UNSOLDER

Découvrez la traduction de unsolder dans 25 langues grâce à notre traducteur anglais multilingue.

Dans cette section, les traductions de unsolder dans d'autres langues ont été obtenues par traduction automatique statistique, où l'unité essentielle de la traduction est le mot «unsolder» en anglais.

• Traducteur Français - chinois: 拆焊
• Traducteur Français - espagnol: desoldar
• anglais: unsolder
• Traducteur Français - hindi: unsolder
• Traducteur Français - arabe: أبعد عن التجنيد
• Traducteur Français - russe: отпаять
• Traducteur Français - portugais: unsolder
• Traducteur Français - bengali: unsolder
• Traducteur Français - français: dessouder
• Traducteur Français - malaisien: Tidak terjual
• Traducteur Français - allemand: löten
• Traducteur Français - japonais: 〜のはんだを取り除く
• Traducteur Français - coréen: 을 벗기고
• Traducteur Français - javanais: Unsolder
• Traducteur Français - vietnamien: unsolder
• Traducteur Français - tamoul: unsolder
• Traducteur Français - marathi: न जुमानणारा
• Traducteur Français - turc: lehimini açmak
• Traducteur Français - italien: dissaldare
• Traducteur Français - polonais: wylutowania
• Traducteur Français - ukrainien: отпаять
• Traducteur Français - roumain: unsolder
• Traducteur Français - grec: ξεκολλώ
• Traducteur Français - afrikaans: lossolderen
• Traducteur Français - suédois: unsolder
• Traducteur Français - norvégien: unsolder

10 LIVRES EN ANGLAIS EN RAPPORT AVEC «UNSOLDER»

Découvrez l'usage de unsolder dans la sélection bibliographique suivante. Des livres en rapport avec unsolder et de courts extraits de ceux-ci pour replacer dans son contexte son utilisation littéraire.

Operator's, Organizational, Direct Support, and General ...

(4) Unsolder two brown wires from lug end of diode (CR11)(43). (5) Remove red wire from terminal 5 (T2) (27). (6) Unsolder gray wire from terminal (El). (7) Unsolder black wire from terminal (E2). (8) Unsolder gray wire from terminal (E5).

‎1992

Operator, Organizational, and Field Maintenance Manual: ...

(2) Unsolder terminal leads of step-down transformer (2, fig. 22), and remove four plain nuts (3, fig. 22), four lock- washers (4, fig. 22), and four machine screws (1, fig. 22). Remove transformer. (3) Unsolder terminal wires at relay (5, fig. 22) and ...

‎1988

Direct Support and General Support Maintenance Manual: ...

(5) Tag and remove (unsolder) cable leads from Rl (3) and CR1 through CR3 (5). See removal procedure in d(6) and d(10) above. (6) Disconnect P3 (6) from load measurement unit. (7) Remove TB1 (5, fig 3-83). See removal procedure in e(5) ...

‎1986

RF Signal Generator AN/URM-25F.

(3) Unsolder the three leads from terminal board TB106. (4) Unsolder ground lead from ground lug adjacent to the attenuator inside front panel. Paragraph 16a (5) Unsolder step attenuator lead from terminal board TB101. (6) Unsolder resistor ...

‎1990

DS, GS, and depot maintenance manual: control, communication ...

Unsolder wires from connector terminals. e. Replace Jl by reversing procedures of a through d above. 3—16. Removal and Replacement of Transformers a. Removal and Replacement of Tl (fig 3-8). To remove Tl (microphone amplifier input ...

United States. Dept. of the Army, 1990

General Support Maintenance Manual: Amplifier-converter ...

4-17. RIBBON CABLE REMOVAL (Figure 4-5). CAUTION Use extreme care when removing or replacing ribbon cables. Creasing or severe bending will damage ribbon cables internally. 1. Unsolder ribbon cable at the following terminal points: ...

‎1986

Operator's, Organizational, Direct and General Support ...

(4) If the PC board and transistor are being replaced as an assembly, scrape away the coating over the solder connections on the foil side of the PC board, and unsolder the wires. NOTE Items 7 through 15 are also available as a complete ...

‎1988

DS, GS, and Depot Maintenance Manual: Receiving Set, Radar ...

(6) Remove first section of capacitor retainer (10); unsolder and tag leads and remove variable capacitors and coils (31). (7) Remove second section of capacitor retainer (11). (8) Unsolder and tag leads, and remove two machine screws, two ...

‎1992

Field and Depot Maintenance Manual: Distributor-transmitter ...

(6) Remove four machine screws (161), four spacers (162), four flat washers (163 ), four lock washers (164), and four nuts (165) holding power supply circuit board A1A4 (160) to brackets (159); remove brackets (159). (7) Unsolder and ...

‎1962

Operator, Organizational, Direct Support, and General ...

e. Unsolder the wires attached to the switch. Wires should be tagged for proper identification during reinstallation. f. To install replacement switch, reverse procedures a through e above. 13.7 Power On-Off Switch Removal and Replacement ...

‎1988

10 ACTUALITÉS CONTENANT LE TERME «UNSOLDER»

Découvrez de quoi on parle dans les médias nationaux et internationaux et comment le terme unsolder est employé dans le contexte des actualités suivantes.

Hacking the Nazis: The secret story of the women who broke Hitler's …

We had to unsolder contacts from wires and put them into separate boxes and they were sold off eventually as army surplus." In the years that followed, the ... «TechRepublic, mars 15»

Guitar Shop 101: Tips for Replacing a 3-way Toggle

Unsolder each wire and then remove the switch by turning the mounting nut counter-clockwise. Some toggle switches have a hex nut and require a deep well ... «Premier Guitar, mars 15»

Need To Do PCB (Circuit Board) Swap For Western Digital My …

Or, I am hoping I can buy another of the exact model, and I will not have to do the firmware transfer, which requires unsoldering and resoldering. Here is what I ... «Tom's Hardware, févr 15»

Mod Garage: Adding an Out-of-Phase Switch to a Telecaster

Choose one of the pickups and unsolder the two pickup wires where they connect to your guitar. Solder the phase switch “out” wires (hot and ground) to the ... «Premier Guitar, juin 14»

Build a Google Glass Alternative for $200

To create the headset, you'll start by dismantling the TV video glasses, unsolder power connections to increase the lengths of wires and put them into the ... «Tom's Guide, avril 14»

Mod Garage: The Fender Greasebucket Tone Circuit

Simply unsolder your tone pot and then connect the new parts as shown in the diagram. (Note that the resistor is soldered in series with the 0.022 μF cap.) ... «Premier Guitar, janv 14»

The NSA regularly intercepts laptop shipments to implant malware …

They say some of this NSA spy coding is embeded in the very hardware that we use. You would have to unsolder a chip that was effected!!!!!!!!!! Neon Frank. «ExtremeTech, déc 13»

Fix Your Onan Clock/Timer Module

Unsolder, remove and replace this capacitor and reassemble — the module should work. Reinstall the module to the control panel, and put it back online. «Radio World, déc 13»

Paris Explosion: At Least One Dead

According to LE Parisien the explosion may have been caused by workers who were trying to unsolder old fuel tanks. Reporters on the scene say that the ... «ValueWalk, sept 13»

Before Appetizers Are Served, a Quick Diagnosis From the Valet

“I used to unsolder the Eproms and flash new coding,” he said, referring to the process of reprogramming the memory chip in the car's computer. “I didn't find it to ... «New York Times, sept 13»