«DIOPTOMETER»に関連する英語の本
以下の図書目録から
dioptometerの使いかたを見つけましょう。
dioptometerに関する本と英語文献で使われた文脈を提供するための簡単な抜粋文。
1
Direct Support and General Support Maintenance Manual ...
(1) With the periscope setup as in paragraph e(4) above, sight through the
dioptometer into the right eyepiece of the periscope and check that the periscope
vertical reticle line coincides with the vertical reticle line of the dioptometer. If it is
not ...
2
Direct Support and General Support Maintenance Manual ...
(2) Carefully position eyepiece assembly and secure with four screws (23) and
four washers (24). /. Test and Adjustment. (1) Use dioptometer, 4931-00-536-
5557, and adjust eyepiece (of the dioptometer) until the dioptometer reticle is
sharp to ...
3
Field and Depot Maintenance Manual: Telescope M103
Eyepiece focus test is made with the aid of a 3X dioptometer. Place the
dioptometer (fig. 19) against the eyepiece assembly. The reticle must appear in
sharpest focus at the center of the field. At this point the dioptometer should have
a reading ...
4
Intermediate direct support and intermediate general support ...
Set dioptometer to read zero diopters. Adjust diopter until reticle (3) is sharp and
clear. Aline dioptometer with cell (2). b. Look through dioptometer and housing (4
). Check focus of reticle (3) in reticle housing (5). Focus must be between +0.25 ...
United States. Dept. of the Army,
1989
5
Elementary Optics and Application to Fire Control Instruments
Dioptometer. The dioptometer (fig 5-22) is a precision instrument useful in
determining accurately the diopter setting of another instrument. It is placed
between the eye and the instrument to be checked. The focusing sleeve of the
dioptometer ...
6
Organizational, Direct Support, and General Support ...
Refer to page 3-55. (2) lnstall and level aiming circle on azimuth test fixture
adapter. Refer to page 3-56. (3) Direct aiming circle line-of-sight into collimator. (
4) Look into dioptometer eyepiece (1) and turn the eyepiece until reticle is in
sharpest ...
7
General Maintenance Procedures for Fire Control Materiel
Dioptometer. a. Description. The dioptometer (fig. 10-4) is a calibrated collimating
telescope. It has a conventional type focusing eyepiece with an attached diopter
scale, a stationary reticle pattern consisting of two lines crossing each other at ...
8
Intermediate Direct Support and Intermediate General Support ...
INSTALLATION: When using dioptometer (3), only a small portion of the gunner's
auxiliary sight reticle (4) can be seen. a. Aim gunner's auxiliary sight (5) at blank,
glare-free, light colored surface. b. Set dioptometer focusing objective (6) to ...
9
Direct Support, General Support, and Depot Maintenance ...
I (a) Use dioptometer 4931-536-5557 and adjust eyepiece until the dioptometer
reticle is sharp to the observers eye. Set the objective tube of dioptometer
between -0.75 to 1.0 diopter. (6) Place dioptometer against the eyepiece of
telescope.
10
Optical Design for Visual Systems
When measuring this setting, an instrument known as a Dioptometer is used. For
most accurate results the entrance pupil of the dioptometer should be located at
the exit pupil of the eyepiece. 5.13 Eyepiece with the Eye It will be informative to ...