CĂRȚI ÎN ENGLEZĂ ÎN LEGĂTURĂ CU «RENDERING COAT»
Descoperă întrebuințarea
rendering coat în următoarea selecție bibliografică. Cărți în legătură cu
rendering coat și extrase din aceasta pentru a furniza contextul de întrebuințare al acestuia în literatura Engleză.
The rendering coat is trovelled hard forcing mortar into joints and over the surface
. The rendering coat is kept wet for at least 2 days, and then allowed to dry
completely. 5. The thickness of final or finishing coat may vary between 2 and 3
mm.
B.C. Punmia; Ashok Kumar Jain; Arun Kumar Jain, 2005
2
Conservation of Building and Decorative Stone
Cut out detached and bulging areas to regular, square-edged shapes, preferably
between architectural elements before preparing the wall. 3. Apply a rendering
coat with a laying-on trowel on to a damp substrate to the general levels required
...
F G Dimes, J. Ashurst, 2007
3
The English Cyclopaedia: Division. Geography. 4v. and Suppl
This coat is called the rendering coat, and in good work it is left with a roughly
trowelled face, able to form a key for the further finishing coate ; but in commoner
descriptions of work, known as laid work, the rendering coat is at once floated, ...
4
Arts and Sciences: Or, Fourth Division of "The English ...
This coat is called the rendering coat, and in good work it is left with a roughly
trowelled face, able to form a key for the further finishing coats; but in commoner
descriptions of work, known as laid work, the rendering coat is at once floated, ...
The first coat is called the base coat or the rendering coat and the last as finishing
coat. In a three-coat plastering used in lime plastering, we have the first coat
called the rendering coat, the second coat called floating coat and the last the ...
6
Vitruvius, the Ten Books on Architecture
Having thus set the vaultings in their places and interwoven them, apply the
rendering coat to their lower surface; then lay on the sand mortar, and afterwards
polish it off with the powdered marble. After the vaultings have been polished, set
the ...
7
The Ten Books on Architecture
Having thus set the vaultings in their places and interwoven them, apply the
rendering coat to their lower surface; then lay on the sand mortar, and afterwards
polish it off with the powdered marble. After the vaultings have been polished, set
the ...
8
Basic Civil Engineering
The first coat (rendering coat) of plaster is generally applied by dashing against
the wall surface between the screeds mentioned above. It is then sprinkled
frequently with sufficient quantity of water and rubbed well by means of floats.
Satheesh Gopi, Gopi, 2010
9
The Ten Books on Architecture
This done, apply a rendering coat of mortar made with burnt brick to this wall,
spread on the layer of stucco, and polish it. 2. But if there is not room enough for
the construction of a wall, make channels with their vents extending to the open
air.
10
Materials for Architects and Builders
... the surface is lightly brushed over to remove loose material. Textured finishes
A variety of finishes can be obtained by working the final rendering coat with a
float, brush, comb or other tool to produce a range of standard textured patterns.
